The impact of the ICT4D project on sustainable rural development using a capability approach: Evidence from Bangladesh

Information and Communication Technology for Development (ICT4D) projects have shown a great promises in recent years. However, simply materializing of ICT4D projects is not enough for minimizing the prevalent digital divide in rural areas in developing countries. For the success of an Information and Communication Technology (ICT) intervention, it is important to consider the capabilities of users, who are responsible for converting ICT resources into outcome. While most of the ICT-related studies are focused on the adoption of actual technologies and influences of different internal and external factors on intervention outcomes, very few studies are focused on evaluating intervention outcomes and redesigning intervention strategies. In this study, I opted for using a conceptual framework following the Capability Approach that simultaneously identifies the influence factors for intervention outcome as well as evaluates the outcome based on Noble Laureate Amartya Sen’s five freedoms concept. A qualitative technique has been chosen to conduct the study. As part of the impact evaluation of an ICT4D intervention, a project known as Union Digital Centres (UDCs) in Bangladesh was selected. A total of ten themes are identified indicating that the outcome of the intervention is contributing to socio-economic and human development. However, the study has revealed that lack of capabilities of users (e.g. prior knowledge and financial inability) bar the UDC programs to fulfill their goals at highest level. This study would practically help the UDC policy makers to adjust the UDC intervention design by addressing the shortcomings of the users to yield higher UDC program outcome. Additionally, this study theoretically contributes in ICT adoption literature by showing that there is a mutual influence between users’ capabilities and ICT-related project outcomes. Finally, using specific case study (ICT4D project in Bangladesh), this study contextualizes Amartya Sen’s five freedoms concept in the ICT-specific context.     

裴沟煤矿典型断裂构造带水化学变化特征

断裂运动是错综复杂的地质作用，物质组成的变化能够通过水质中阴阳离子含量直观表现。以裴沟煤矿近20年来的突（涌）水点化验数据为依据探究各含水层水化学普遍性质，发现阳离子含量和矿化度可以作为水源判别的重要指标，以典型构造浮山寨断层为对象研究断裂构造带水化学变化特征，结果显示距离断裂构造带越近，水中Ca²⁺+Mg²⁺含量减小、Na⁺+K⁺含量增大、矿化度降低，揭示断层两盘不同含水层间水掺和程度。     

Developing microencapsulated 12‐hydroxystearic acid (HSA) for phase change material use

Phase change materials (PCM) have an increasingly more important role as a thermal energy storage (TES) media. However, leakage problem of PCM causes limitation during their integration in TES systems. Therefore, the encapsulation of PCMs is attracting research interest to extend usage of PCMs in real TES applications in recent years. In this study, hydroxystearic acid (HSA) was encapsulated with polymethyl methacrylate (PMMA) and different PMMA comonomer shells via emulsion polymerization method for the first time in literature. HSA with high melting temperature range (74–78°C) can widen the scope of using PCMs, and the encapsulated form can make it more versatile. The chemical structures, morphologies, and thermophysical properties of capsules were determined by FT‐IR, SEM, DSC, TGA, and thermal infrared camera. Among the produced HSA capsule candidates, PMMA‐HEMA is the most promising with latent heat of 48.5 J/g with melting range of 47 to 85°C. SEM analysis indicated that the capsules have spherical shape with compact surface at nano‐micro (100–440 nm) size range; however, some capsules exhibited agglomeration.     

Outcome‐based ventilation: A framework for assessing performance,health, and energy impacts to inform office building ventilation decisions

This article presents an outcome‐based ventilation (OBV) framework, which combines competing ventilation impacts into a monetized loss function ($/occ/h) used to inform ventilation rate decisions. The OBV framework, developed for U.S. offices, considers six outcomes of increasing ventilation: profitable outcomes realized from improvements in occupant work performance and sick leave absenteeism; health outcomes from occupant exposure to outdoor fine particles and ozone; and energy outcomes from electricity and natural gas usage. We used the literature to set low, medium, and high reference values for OBV loss function parameters, and evaluated the framework and outcome‐based ventilation rates using a simulated U.S. office stock dataset and a case study in New York City. With parameters for all outcomes set at medium values derived from literature‐based central estimates, higher ventilation rates’ profitable benefits dominated negative health and energy impacts, and the OBV framework suggested ventilation should be ≥45 L/s/occ, much higher than the baseline ~8.5 L/s/occ rate prescribed by ASHRAE 62.1. Only when combining very low parameter estimates for profitable impacts with very high ones for health and energy impacts were all outcomes on the same order. Even then, however, outcome‐based ventilation rates were often twice the baseline rate or more.     

搅拌式风力致热装置启动性能研究

搭建搅拌式风力致热试验台,以自制的2种致热器为研究对象,使其分别在3个不同平均角加速度24.92、14.66、8.04 rad/s2下启动。通过动态扭矩测试仪和数据采集仪测试记录致热器启动阶段的相关数据。结果表明:致热器启动时所需扭矩与角加速度的一次方、转速、叶片半径的二次方成正比,同时得出这些因素之间的关系式;满负荷时,启动扭矩会出现一个峰值,且角加速度越大峰值越大,自然风必须提供峰值以上的扭矩,否则装置无法启动。     

Discrete-time setpoint-triggered reset integrator design with guaranteed performance and stability

According to Bode's gain-phase relationship, in linear time-invariant controllers, introducing an integral action to eliminate the steady-state error has an adverse effect of increased phase delay and overshoot, leading to performance deterioration. Moreover, increasing the bandwidth of the closed-loop system to enhance the low-frequency disturbance rejection invariably amplifies the sensitivity to high-frequency disturbances. Hence, the performance of the linear controllers is always limited due to these fundamental frequency- and time-domain limitations. Motivated by the desire to address the fundamental limitations of linear controllers and improve the time-varying closed-loop performance, we put forward a novel setpoint-triggered reset integrator strategy that varies the integrator cut-off frequency based on the setpoint information. Particularly, to tackle the time-varying disturbances and setpoint profiles, the proposed controller consists of a nominal linear controller and a variable-gain reset integrator. We show the global asymptotic stability of the proposed methodology using positive-real lemma along with the LaSalle's invariance principle and experimentally validate using measured frequency response function. Moreover, the efficacy of the proposed technique compared to that of the linear controller is experimentally demonstrated on a benchmark rotary servo system. Experimental results assessed using the tracking error and cumulative power spectral density substantiate that the proposed control strategy can not only improve the low-frequency disturbance rejection but also augment the high-frequency trajectory tracking performance.     

温拌LDPE改性沥青混合料性能研究

选择Sasobit和Evotherm 3G两种温拌剂对温拌LDPE沥青混合料制备工艺和性能进行研究。首先,比较变温等体积法和等黏温度法两种方法,并确定两种温拌混合料的拌和及击实温度。在此基础上,分别采用车辙试验、低温弯曲试验、中点加载弯曲试验以及冻融劈裂试验评价70#、LDPE、Sasobit-LDPE以及3G-LDPE四种沥青混合料的高温性能、低温性能、疲劳性能和水稳定性。结果表明,两种温拌技术均是可行的,Sasobit和3G温拌技术可使施工温度降低20℃和15℃。与热拌LDPE沥青混合料相比,Sasobit温拌沥青混合料具有更好的高温性能和水稳定性,在高应力比条件下抗疲劳性能更好,低温性能虽变差,但是优于70#沥青混合料;3G温拌沥青混合料的高温性能,低温性能以及水稳定性则与热拌LDPE沥青混合料各项性能较为接近,抗疲劳性能变差,但是优于70#沥青混合料。     

高性能有机氟材料制备科学及应用进展

有机氟材料具有优异的热氧稳定性、耐化学腐蚀性、耐老化性、不黏性、电绝缘性以及极小的摩擦系数等特性，因此作为一种不可替代的材料广泛应用于高新技术产业。近年来高新技术产业发展对高性能有机氟材料的需求引发了学术界和工业界对氟材料的研究兴趣。依据本文作者的研究经历及有机氟材料的发展方向，本文介绍了氟树脂（新型含氟聚合物、电活性含氟聚合物、新型全氟磺酸聚合物、聚四氟乙烯3D打印）及氟橡胶（过氧化物硫化氟橡胶、耐低温氟醚橡胶、耐高温全氟醚橡胶、全氟聚醚基类玻璃橡胶）的制备科学及应用进展，特别阐述为了满足航空航天、能源、信息等高新技术产业需求发展的新一代高性能有机氟材料。本文也介绍了近期出现的聚四氟乙烯新成型技术及类玻璃氟橡胶。文章指出发展绿色环保和高效的高性能有机氟材料制备及成型加工方法是今后的发展方向。     

Sustainable supply chain management in Indian organisations: an empirical investigation

The present work is an attempt to investigate the adoption of sustainable supply chain management (SSCM) practices amongst manufacturing and process based organisations in India and its impact on organisational performance encompassing all three dimensions of sustainability. SSCM practices conceived in the present study include environmental management practices (EMP), socially inclusive practices for employees (SPE), socially inclusive practices for community (SPC), operations practices (OP) and supply chain integration (SCI) which were treated as exogenous variables. Organisational performance considered in this study includes five dimensions, namely environmental performance (EPR), employee-centred social performance (ESP), community-centred social performance (CSP), operations performance (OPR) and competitiveness, which were regarded as endogenous variables. The analysis was carried out with the help of structural equation modelling considering natural logarithm of manpower as a control variable. Few major findings are mentioned. EMP does not have any significant association with OPR, nor does it result in competitiveness. However, when jointly mediated through both EPR and OPR, EMP leads to competitiveness. SPC has significant negative association with competitiveness, when only direct relationship is considered. However, indirect relationship between SPC and competitiveness shows significant positive association when mediated through CSP. The resultant total effect between SPC and competitiveness turns out to be insignificant. Further, OPR fully mediates the relationship between OP and competitiveness. Managerial implications of the findings are discussed.